Ⅰ. Waste Oil Recycling Plant Process Principle
Waste oil recycling plant process adopts domestic advanced decompression thin film molecular flash evaporation technology. Under high vacuum conditions (absolute pressure 10Pa), high-viscosity components can be distilled out at a lower temperature, and high-temperature cracking and polymerization are also reduced , Equipment blockage and other problems. No secondary pollutants such as acid slag, waste acid and waste water are generated. It is a clean, environmentally friendly, and appropriate investment regeneration process.
It can be seen that molecular distillation has the following advantages:
1. Due to the low operating temperature and short heating time of molecular distillation, products with high purity and good original quality can be obtained.
2. The product cost is low. Because of the high separation efficiency and recovery rate of molecular distillation, the cost can be greatly reduced.
Ⅱ. Waste Oil Recycling Plant Flow Chart
Ⅲ.Waste Oil Recycling Plant Models and Parameters
Model designation | Unit | KTS-R2-5 | KTS-R15 | KTS-R20 | KTS-R30 | KTS-R50 | KTS-R100-200 | |||
Handling Capacity | T/D | 2-5 | 15 | 20 | 30 | 50 | 100-200 | |||
Working Pressure | Mpa | ≤0.5 | ||||||||
Working vacuum | pa | -5~ -20 | ||||||||
Temperature | ℃ | ≤350 | ||||||||
Working Noise | dB （A） | ≤85 | ||||||||
The power | V | 380-480V/50-60Hz Three-phase four-wire（Customizable as required） | ||||||||
Total Power | KW | 80 | 120 | 125 | 140 | 200 | 300-600 | |||
Cooling Water | M³ | 35 | 40 | 50 | 60 | 80 | ||||
Weight | T | 16 | 19 | 22 | 26 | 46 | ||||
Dimension | L | m | 15 | 17 | 17 | 25 | 45 | |||
W | m | 4 | 6.5 | 10 | 12 | 16 | ||||
H | m | 6 | 6 | 6 | 6 | 6.5 | ||||
Notification | 1.We can customize 150 -300TPD equipment as required 2.Diesel and natural gas heating method will be more economical. | |||||||||
